kingtone 2g 3g 4g triple band signal booster

Cheap signal booster 3g 4g factory signal amplifier Kingtone repeater

Installation Steps

How to install a mobile phone signal booster in a small house

1. Find an appropriate position for an outdoor antenna.

Requirements to outdoor antenna installation:

• outdoor antenna should be installed on the roof of the house or in some other place where your mobile device is within coverage zone. Mobile signal should be strong, at least three-four bars indicated on your phone display.
• outdoor antenna should be fixed in straightly

1. Plug in the outdoor antenna to the mobile booster from BS side and fasten tightly.
2. Plug in the indoor antenna to the mobile booster from MS side and fasten tightly.

Requirements to indoor antenna installation:

• indoor antenna should be at 5-meter distance from an outdoor antenna
• indoor antenna should be at least 2 meters above the ground
• indoor antenna should be fixed vertically with the ground.

1. Connect the signal booster to the Power Supply.

Some models have an inbuilt Power Supply. Please, examine the manual applied to your model, if your signal repeater kit doesn’t include separate Power Supply, skip this step!

If the light indicator on the booster turns on it means the installation has been implemented correctly.

Note: Switch on the signal booster only after you connect outdoor and indoor antennas in the proper way!

1. Test the signal of your mobile telephone – a maximum quantity of bars should be indicated on the display of your phone in each corner of the location within booster coverage zone. In case the mobile signal is still instable try to change the position of the outdoor antenna for more proper one.

Important notes for installation:

• Cables from outdoor antenna should not be wound and be placed as straight as possible in order not to create any hindrance for signal reception and its transmission.
• Cables should be shortened to the acceptable maximum so that not to waste or decrease mobile signal coverage range.
• In order to prevent water from coming into the mobile phone booster through the cable make a loop in it.
• Keep the outdoor antenna as far as possible from frequency aerials, high voltage cables, metal nets or transformers.

dd

  dd

■ contat supplier ■ Solution&Application

• *Model : KT-100-03
  *Product Category : 100W RF Coaxial Attenuator

  

• *Model : KT–8090-18
  *Product Category : 824-960MHz GSM CDMA 800MHz 900MHz Directional 18dBi Yagi Antenna

  

• *Model : KT-DRP-B75-P37-B
  *Product Category : 5W DCS1800MHz Band Selective Repeaters

  

• *Model : KT-TETRA400 Repeater
  *Product Category : 5w 37dbm TETRA 400mhz band selective RF repeater