Wholesale Price Cell Phone Repeater Antenna - UHF 400Mhz 2W Band Selective walkie talkie Repeater – Kingtone Detail:
- Introduction
- Mainfeature
- Application&scenarios
- Specification
- Parts/Warranty
-
400M 2W Band Selective Repeaters（KT-CRP-B5-P33-B）
Kingtone Repeaterskintone repeater system is designed to solve problems of weak mobile signal, which is much cheaper than adding a new Base Station (BTS). Main operation of RF Repeaters system is to receive low‐power signal from BTS via radio frequency transmission and then transmit the amplified signal to the areas where network coverage is inadequate. And the mobile signal is also amplified and transmitted to the BTS via the opposite direction.Telephone repeater
This is used to increase the range of telephone signals in a telephone line. They are most frequently used in trunklines that carry long distance calls. In an analog telephone line consisting of a pair of wires, it consists of an amplifier circuit made of transistors which use power from a DC current source to increase the power of the alternating current audio signal on the line. Since the telephone is a duplex (bidirectional) communication system, the wire pair carries two audio signals, one going in each direction. So telephone repeaters have to be bilateral, amplifying the signal in both directions without causing feedback, which complicates their design considerably. Telephone repeaters were the first type of repeater and were some of the first applications of amplification. The development of telephone repeaters between 1900 and 1915 made long distance phone service possible. However most telecommunications cables are now fiber optic cables which use optical repeaters (below).Cellular repeater
This is a radio repeater for boosting cell phone reception in a limited area. The device functions like a small cellular base station, with a directional antenna to receive the signal from the nearest cell tower, an amplifier, and a local antenna to rebroadcast the signal to nearby cell phones. It is often used in downtown office buildings.
- Mainfeature
-
Main Features of kingtone cellular repeater
◇ High linearity PA; High system gain；
◇ Intelligent ALC technology；
◇ Full duplex and high isolation from uplink to downlink；
◇ Automatic Operation convenient operation；
◇ Integrated technique with reliable performance;
◇ Bandwidth can be configured from 5-25MHz in work band.
◇ Local and remote monitoring (optional) with automatic fault alarm &remote control;
◇ Weatherproof design for all-weather installation;
- Application&scenarios
-
TETRA 400 repeater Applications
To expand signal coverage of fill signal blind area where signal is weak
or unavailable.
Outdoor: Airports, Tourism Regions, Golf Courses, Tunnels, Factories, Mining Districts, Villages etc.
Indoor: Hotels, Exhibition Centers, Basements, Shopping
Malls, Offices, Packing Lots etc.
It is mainly applicable to such case:
The repeater can find an installation place which can receive pure BTS signal at strong enough level as the Rx Level in repeater site should be more than ‐70dBm;And can meet the requirement of antenna isolation to avoid self‐oscillation.
- Specification
-
Items
Testing Condition
Specification
Uplink
Downlink
Working Frequency(MHz)
Nominal Frequency/customized
410 – 415MHz
420 – 425MHz
Gain(dB)
Nominal Output Power-5dB
80±3
Output Power (dBm)
33
33
ALC (dBm)
Input Signal add 20dB
△Po≤±1
Noise Figure (dB)
Working in-band（Max. Gain）
≤6
Ripple in-band (dB)
Nominal Output Power -5dB
≤4.0
Time Delay (us)
Working in-band
≤5
Gain Adjustment Step (dB)
Nominal Output Power -5dB
1dB
Gain Adjustment Range(dB)
Nominal Output Power -5dB
≥30
Gain Adjustable Linear(dB)
10dB
Nominal Output Power -5dB
±1.0
20dB
Nominal Output Power -5dB
±1.0
30dB
Nominal Output Power -5dB
±1.5
Out of Band Gain
±400KHz
Nominal Output Power -5dB
≤50
±600KHz
Nominal Output Power -5dB
≤40
±1MHz
Nominal Output Power -5dB
≤35
±5MHz
Nominal Output Power -5dB
≤25
Inter-modulation Attenuation (dBc)
Working in-band
≤-45
Spurious Emission(dBm)
9kHz-1GHz
BW:30KHz
≤-36
≤-36
1GHz-12.75GHz
BW:30KHz
≤-30
≤-30
VSWR
BS/MS Port
1.5
I/O Port
N-Female
Impedance
50ohm
Operating Temperature
-25°C ~+55°C
Relative Humidity
Max. 95%
MTBF
Min. 100000 hours
Power Supply
DC-48V/AC220V(50Hz)/AC110V(60Hz)( ±15%)
Remote Monitoring Function
Real-time alarm for Door Status, Temperature, Power Supply, VSWR, Output Power
Remote Control Module
RS232 or RJ45 + Wireless Modem + Chargeable Li-ion Battery
- Parts/Warranty
-
warranty :1year for repeater ,6months for accessories
■ contat supplier ■ Solution&Application
-
*Model : KT-17P
*Product Category : 65 °-17dBi base Panel directional antenna (824-960MHz/1710-2700MHz)
-
*Model : KT-G/DRP-B25/75-P43-B
*Product Category : 20W High power outdoor repeater,43dbm GSM900/DCS1800 20W Wide band Repeater -
*Model : KTWTI-7-08/2.5V-G
*Product Category : G Indoor Directional Ceiling Antenna -
*Model : KT-3G/B60-P10
*Product Category : 10W High Output Power Outdoor/Indoor 3G UMTS/HSDPA WCDMA Fiber Optical Repeater 2100MHz Signal Amplifier
-
Product detail pictures:
Related Product Guide:
What is MIMO?
Usually customer-oriented, and it's our ultimate focus on to be not only by far the most reliable, trustable and honest provider, but also the partner for our customers for Wholesale Price Cell Phone Repeater Antenna - UHF 400Mhz 2W Band Selective walkie talkie Repeater – Kingtone, The product will supply to all over the world, such as: Chile, Mecca, New Orleans, All the imported machines effectively control and guarantee the machining precision for the products. Besides, we have a group of high-quality management personnels and professionals, who make the high-quality products and have the ability to develop new products to expand our market home and abroad. We sincerely expect customers come for a blooming business for both of us.
By Helen from Ecuador - 2018.08.12 12:27
The factory has advanced equipment, experienced staffs and good management level, so product quality had assurance, this cooperation is very relaxed and happy!
By Priscilla from Auckland - 2017.10.27 12:12
